Parts kit, Step two, Step one – Pavement Ends 51137 Replay User Manual
Page 2: Step three, Step four

51137 pg 2
Rev. D 0204
Parts Kit
Top Fabric Assembly
Qty - 1
Rear Curtain (Window)
Qty - 1
Note: Before beginning this installation,
remove the old top. Keep the white
fiberglass rod from the old top for use
in Step 10.
Step Two
With the bow up and the hardware in place, drape the top over the
hardware. Hook the five clips on the front of the top into the slots
in the windshield header.
Step One
Unlock the windshield retainer and
open it back.
Windshield Retainer
Sun Visor
Hook clips into slots in
windshield header
Push buttons on windshield latch to
release windshield retainer
Step Three
Snap the five snaps on the inside of
the top to the studs on the rear bow.
View from inside top
Snap to rear
bow
Rear Bow
Rear Corner Retainer
Slip plastic clip under
retainer
Step Four
Locate the plastic clips sewn into each rear corner of the top. Pull down and
back on the top fabric and slip them into the space under the plastic corner
retainer attached to the vehicle. The stop on the inside edge of the plastic clip
on the top should line up with the inside edge of the retainer.
The stop on the plastic clip, sewn to the top,
must line up with the edge of the Rear Corner
Retainer.