Pavement Ends 51144 Replay - Manual (Page 8)

51144 pg 8 1206 Rev. C
Step Twenty-three
I NSTALL N EW D OOR F ABRIC
Unzip the windows and separate the hook and loop fasteners on the door covers. Lay the door cover on a fl at smooth
surface with the outside facing down.
Start by working the lower rear corner of the door frame into the pocket in the lower rear corner of the cover. Then work the
lower front corner of the frame into the cover. Work the top front corner of the frame into the corner of the cover, between
the hook and loop fl aps (not between the zipper and the fl ap). Finally, use the tab sewn into the cover to work the last cor-
ner of the frame into the corner of the door cover, again between the hook and loop fl aps.
Make sure that the top edge of the door cover is straight along the top of the door frame. Work around the door fastening
the hook and loop strips tightly around the door frame. Once the door cover is on the frame, the tab in the top rear corner
of the cover may be cut off with a pair of scissors if desired.
NOTE: For the best results and to minimize scratches on the windows, remove all jewelry before installing the door covers.
NOTE: This door cover is designed to fi t very tight on the door frame. We recommend using a shoe horn to help work the
corners of the cover over the frame without tearing the fabric.
Do not pull on the weatherstrip to assist in getting the door cover on the door frame.
This will tear the weatherstrip and the door will not seal properly.
Door Frame Between
Hook and Loop Flaps
1. Install Lower
Rear Corner
3. Install Upper
Front Corner
Unzip Window
before installing
Hook and Loop
Weatherstrip
4. Use tab to install
Upper Rear Corner
2. Install Lower
Front Corner
Detail of Hook and Loop -
Lower Front Corner
Pull Flap
Up First
Hook and
Loop
Detail of Hook and
Loop - Top of Door
Step Twenty-four
R EINSTALL D OORS
Reinstall the upper doors. Insert the pins into the grommets in the lower door.