Flavoring wood – Brinkmann 810-3810-S User Manual
Page 17
16
To obtain your favorite smoke flavor, experiment by using chunks,
sticks or chips of flavor producing wood such as hickory, pecan, apple,
cherry, or mesquite. Most fruit or nut tree wood may be used for
smoke flavoring. Do not use resinous wood such as pine as it will
produce an unpleasant taste.
Wood chunks or sticks 3" to 4" long and 1" to 2" thick work best.
Unless the wood is still green, soak the wood in water for 30 minutes
or wrap each piece in foil and tear several small holes in the foil to
produce more smoke and prevent the wood from burning too quickly.
A lot of wood is not required to obtain a good smoke flavor. A
recommended amount for the Professional Grill is 5 to 6 wood chunks
or sticks. Experiment by using more wood for stronger smoke flavor
or less wood for milder smoke flavor.
Additional flavoring wood should not have to be added during the
cooking process. However, it may be necessary when cooking very
large pieces of food. Follow instructions and cautions in the “Adding
Charcoal/Wood During Cooking” section of this manual to avoid injury
while adding wood.
Flavoring Wood
Step 5
Place cooking grill on grill support lips. Use charcoal grate adjuster
crank to position charcoal grate to desired cooking level.
WARNING:
Wear protective gloves or oven mitts when adjusting door
handle, ash tray or cooking height.
Step 6
Place food on cooking grill and close grill lid. Always use a meat
thermometer to ensure food is fully cooked before removing from
grill.
Step 7
Allow grill to cool completely, then follow instructions in the
“After-Use Safety” and “Proper Care & Maintenance” sections
of this manual.
INSTR_810-3810-S.qxd 11/16/07 9:58 AM Page 17