BT 4010 Executive - Manual (Page 61)

To set the recall time
You need only adjust this setting
if your switchboard requires a
different recall time to the
pre-set recall time of 100ms .
Press the Menu options button.
Press the DOWN navigation
button until the display shows
Base Set .
Press the OK options button.
Press the DOWN navigation
button until the display shows
Add Features .
Press the OK options button.
Press the DOWN navigation
button until the display shows
TBR .
Press the OK options button.
Press the DOWN navigation
button to select the flash time
80 , 100 , 120 , 180 , 250 or
300ms .
Press the OK options button to
confirm. The display shows
Saved .
Press the RED PHONE button
until you reach the idle display.
Diverse 4010 Executive ~ 9th Edition ~ 17th July ~ 3662
Menu
OK
OK
OK
OK
59
To switch temporarily from
pulse to tone dialling
If you are using pulse dialling
with your switchboard but
need tone dialling to use
certain functions on your
Diverse 4010 you can switch to
tone dialling during the call.
During your call:
Press the Menu options button.
Press the DOWN navigation
button until the display shows
Temp.Tone .
Press the OK options button.
Tone dialling is now active.
Press the RED PHONE button
until you reach the idle display.
Menu
OK
Note
This setting is only for the duration of
the call.
Note
100 MS is the standard setting for
most UK switchboards.
GENERAL
INFORMA
TION