Multiquip DCA500SSK - Manual (Page 50)

PAGE 50 — DCA-500SSK — PARTS AND OPERATION MANUAL (STD) — REV. #1 (04/14/01)
9. The generator's frequency meter (Figure 40) displays
the 60 cycle output frequency in HERTZ.
Figure 40. Frequency Meter (Hz)
4. Close all engine enclosure doors (Figure 34).
Figure 34. Engine Enclosure Doors
Figure 38. Off/Manual/Auto Switch (Manual)
8. After engine starts, verify that the "Engine Running"
status LED (Figure 39) on the Microprocessor Engine
Control Module (MPEC) display is "ON" (lit).
DCA-500SSK — GENERATOR START-UP PROCEDURE (MANUAL)
Figure 39. MPEC Engine Running Status LED
7. Place the Off/Manual/Auto switch (Figure 38) in
the MANUAL position (down). Observe that the
engine begins to crank.
6. When starting the generator in COLD weather
conditions, press and hold the engine preheat button
(Figure 36) until the preheat lamp (Figure 37) is lit
(ON).
Figure 36. Engine Pre-Heat Button
Figure 37. Engine Pre-Heat Lamp
5. Set the battery ON/OFF switch (Figure 35) to the ON
position.
Figure 35. Battery ON/OFF Switch