Multiquip DCA70SSJU3 - Manual (Page 39)

DCA-70SSJU3 (60 Hz) — OPERATION AND PARTS MANUAL — REV. #0 (05/10/06) — PAGE 39
1
NORMAL SHUT-DOWN
To shutdown the generator, use the following procedure:
1. Switch the MAIN, AUX and GFCI circuit breakers
(Figure 54) to the “OFF” position (no load).
Figure 54. Main, AUX. and GFCI
Circuit Breakers (OFF)
EMERGENCY SHUT-DOWN SHUTDOWN
1. To shut-down the engine in the event of an emergency,
switch the MAIN, GFCI and LOAD (Figure 54) circuit
breakers to “OFF” position.
2. Place the Auto-Off/Reset-Manual switch (Figure 55) in
the AUTO/RESET position (center).
2. Let the engine cool by running it for 3-5 minutes with no
load applied (circuit breakers in the off position).
3. Place the Auto-Off/Reset-Manual switch (Figure 55) in
the AUTO/RESET position (center).
Figure 55. Auto-Off/Reset Switch (Auto/Reset)
4. Verify that the all status LED on the MPEC display
are OFF (not lit).
5. Remove all loads from the generator.
6. Inspect entire generator for any damage or loosening of
components that may have occured during operation.
1. Perform steps 1 through 5 in the Before Starting section
as outlined in the Manual Starting Procedure.
2. Place the MPEC Control Switch (Figure 53) in the AUTO
position .
3. Continue to follow the steps outlined in the Manual Start-
up procedure (start at step 9).
Figure 53. MPEC Control Switch (AUTO)
NEVER stop the engine suddenly except in an emergency.
DO NOT use the emergency stop switch a as method of
shutting down the generator. This switch is ONLY to be
used in the event of an emergency.
WARNING - SHUTTING DOWN THE GENERATOR
DCA-70SSJU3 (60 Hz) — GENERATOR SHUTDOWN