Multiquip DCA70SSJU3 - Manual (Page 38)

PAGE 38 — DCA-70SSJU3 (60 HZ) — OPERATION AND PARTS MANUAL — REV. #0 (05/10/06)
17. Turn the main, GFCI, and aux. circuit breakers to the
“ON” position (Figure 51).
18. Observe the generator's ammeter (Figure 52) and verify
it reads the anticipated amount of current with respect
to the load. The ammeter will only display a current
reading if the load is in use.
19. The generator will run until manually stopped or an
abnormal condition occurs.
Figure 52. Ammeter (Load)
Figure 51. Main, AUX. and GFCI
Circuit Breakers (ON)
When the generator is set in the
AUTO mode, the generator will
automically start in the event of
comercial power falling below a
prescribed level by means of a
contact closure that is generated
automatically by a transfer switch.
NOTE
Starting (Auto Mode)
Before connecting this generator to any
building’s electrical system, a
licensed
electrician must install an isolation
(transfer) switch. Serious damage to the
building’s electrical system may occur
without this transfer switch.
DANGER - ELECTRICAL SYSTEM HAZARDS
When connecting the generator to a isolation (transfer)
switch, ALWAYS have power applied to the generator's
internal battery charger. This will ensure that the engine
will not fail due to a dead battery.
When running the generator in the AUTO mode, remember
the generator can start up at any time without warning.
NEVER attempt to perform any maintenance when the
generator is in the auto mode.
When the MPEC Control Switch
is placed in the AUTO position,
the engine glow plugs will be
warmed and the engine will start
automatically.
NOTE
WARNING - AUTO MODE MAINTENANCE
CAUTION - BACKUP GENERATOR USE
DCA-70SSJU3 (60 Hz) — GEN. START-UP PROCEDURE (AUTO MODE)