Multiquip TP24X - Manual (Page 8)

page 8 — Tp24X TILe SaW • operaTIon and parTS manuaL — rev. #2 (04/12/12)
safety infOrMatiOn
SaW SaFeTy
danger
„ never operate the equipment in an explosive atmosphere
or near combustible materials. An explosion or fi re could
result causing severe bodily harm or even death.
WarnIng
„ Accidental starting can cause severe injury
or death. aLWayS place the ON/OFF
switch in the OFF position.
„ Keep hands away from moving parts at all
times.
„ never disconnect any emergency
or safety devices. These devices are
intended for operator safety. Disconnection of these
devices can cause severe injury, bodily harm or even
death. Disconnection of any of these devices will void
all warranties.
CauTIon
„ aLWayS ensure saw is securely placed on appropriate
blocks or jackstands when maintenance requires
elevation of the saw.
„ If the machine malfunctions, stop the saw immediately
and secure it. Fix the problem as soon as possible.
NOTICE
„ aLWayS keep the machine in proper running condition.
„ Fix damage to machine and replace any broken parts
immediately.
„ Make sure there is no buildup of grease, oil or debris
on the machine.
„ aLWayS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
BLade SaFeTy
WarnIng
„ Rotating blade can cut and crush. aLWayS
keep hands and feet clear while operating
the saw.
CauTIon
„ never operate the saw without blade
guards and covers in place. Exposure of
the diamond blade must not exceed 180
degrees.
„ Verify the motor start switch is set to the OFF position
before installing a blade.
„ aLWayS inspect blade before each
use. The blade should exhibit no cracks,
dings, or fl aws in the steel centered core
and/or rim. Center (arbor) hole must be
undamaged and true.
NOTICE
„ Use proper blades and follow blade manufacturer’s
recommendations. Match the blade RPM (blade shaft
RPM) to the recommended blade surface feet per minute
(SFPM).
„ Ensure the blade-mounting bolt is tightened
adequately
„ aLWayS examine blade flanges for damage and
excessive wear.
„ Ensure the blade is marked with an operating speed
greater than the spindle speed of the saw.
„ Only cut the material that is specifi ed for the diamond
blade. Read the specifi cation of the diamond blade to
ensure the proper tool has been matched to the material
being cut.
„ If wet cutting, ensure a WeT CuTTIng blade is being
used and that the water supply system to the blade is
properly functioning and being used.
„ do noT drop the diamond blade on ground or
surface.
„ Ensure that the blade is mounted for proper operating
direction.
„ Adhere to the blade manufacturer’s recommendations
on handling, storage and safe usage of blades.