Multiquip TP24X - Manual (Page 23)

Tp24X TILe SaW • operaTIon and parTS manuaL — rev. #2 (04/12/12) — page 23
OperatiOn
3. Push the cutting table with the material, slowly and
evenly until the cut is complete. Move the cutting table
back and remove the cut pieces.
4. Avoid overloading the motor when cutting. However,
the electric motor is protected with a manual-reset
thermal overload switch that will turn the saw off if the
motor is overheated. In the event that the switch is
tripped, turn the “ON/OFF” switch to the “OFF” position
and allow the motor to cool before attempting to restart.
SHuT doWn proCedure
1. Place the power ON/OFF switch (Figure 17) in the OFF
position (down).
Figure 17. Power ON/OFF Switch (OFF)
2. Wait for the cutting blade to stop rotating.
3. Disconnect the saw's AC power cord from the power
source. never leave the saw connected to a power
source when unattended. This will prevent accidental
starting.
4. Using a soft cloth, clean any excess debris or residue
that may have accumulated on the saw.
5. Store saw in a clean dry location where it will be out
of the reach of children.