Multiquip MRH800DS2 - Manual (Page 17)

MRH800DS2 VIBRATORY ROLLER • OPERATION AND PARTS MANUAL — REV. #1 (04/12/11) — PAGE 17
COMPONENTS
Figure 2 illustrates the location of the major components
for the MRH800DS2 Vibration Roller. The function of each
component is described below:
1. Fuel Tank/Cap — Fill with diesel fuel. Fuel tank holds
approximately 2 gallons (7.5 liters). DO NOT top off
fuel. Wipe up any spilled fuel immediately.
2. Center Cover — When opened and supported by strut,
provides access to oil pump and fi lter, battery, V-belt,
and clutch box.
3. Vibration Rollers — 25-inch wide steel drums that
provide compaction force in the compaction and
patching of asphalt type surfaces.
4. Front Headlights — Activate using switch on control
handle. Use to illuminate ground during nighttime or
low-light operating conditions.
5. Hydraulic Oil Gauge — Indicates the hydraulic oil
level.
6. Oil Tank — Fill with proper grade of hydraulic oil.
7. Vibrator Oil Level Plug — Remove to check vibrator
oil level.
8. Lifting Hook — Used to lift the machine with crane or
other lifting device.
9. Engine — This machine uses the Yanmar
L100V1AJ1R1AAMK engine. Refer to the engine
Owner’s Manual for more information.
10. Water Tank — Holds 10.57 gallons (40 liters) for the
sprinkler system.
11. Parking Brake — Makes sure machine will not
accidentally move when parked or not in use.