MTS Series 322 Load Frame Lifting and Moving - Manual (Page 12)

Description Item
Parallel 1
110 N·m (80 lbf·ft) 2
Clamp position mark 3
75 N·m (55 lbf·ft) 4
a) If the lift bracket has been removed, reinstall it, hand tightening the cap screw that goes into the
crosshead.
b) Raise the piston. Hand tighten the cap screw that goes into the piston.
c) Torque the crosshead’s cap screw to 34 lbf·ft (46 N·m). Torque the piston’s cap screw to 80 lbf·ft (110
N·m).
d) Repeat this step to install the other lift cylinder.
7. Connect the hose at the cylinders’ end caps.
12 Series 322 Load Frame Lifting and Moving
Lift and Move