MTS Hydraulic Service Manifold Model 293-12B - Manual (Page 38)

Description Item
Top View 7
Return Out -16 8
Pressure In -16 9
Filter Drain -06 (maintenance only) 10
Drain Out -06 to HPU 11
Hydrostatic Bearings Controlled Pressure -04 12
Pressure -16 13
Return -16 14
Pilot Return -06 15
Drain -06 16
Note:
The filter drain is provided for maintenance of the filter. The drain port is at the same hydraulic
pressure as the HPU. Ensure that hydraulic pressure to the HSM is turned off before using this drain
port.
Series 293.1X HSM Electrical Connections
The 293.1X HSM is equipped with a control manifold that permits selection of various hydraulic pressures.
Control cable connections must be made between the high and low solenoids of the HSM and the system
controller. The following figure shows the locations of the high/low solenoids.
38 | Series 293 Hydraulic Service Manifold Product Information
Installation