MTS Series 505 SilentFlo Hydraulic Power Unit Model 505-11 - Manual (Page 68)

Model 505.07/.11 SilentFlo™ HPU 68
High Pressure Filter Kit
Accessories
High Pressure Filter Kit
This section describes how to install the high pressure filter kit (part number 100-
008-737).
To install the high pressure filter kit:
1. Ensure that system hydraulic pressure has been reduced to zero before
proceeding. To do this, turn off the hydraulic power unit and exercise the
actuator until it stops moving.
2. Remove the hose assembly connecting the high pressure port on the
manifold assembly to the high pressure output port.
3. Connect the elbow to the input of the filter assembly. Connect the straight
tube to the output of the filter assembly.
High Pressure Filter Components
4. Connect the elbow of the filter assembly to the high pressure port on the
manifold assembly.
5. Connect the high pressure hose between the filter assembly and the high
pressure output port.
6. Turn on the hydraulic pressure and check for leaks.
Replacing the Filter
Element
The high pressure filter should be changed every 1000 hours or six months, or
when the Dirty Filter indicator is lit. You will need a filter element (MTS part
number 100-030-007) or a filter kit (MTS part number 100-030-194).
High
Pressure
Port
Elbow
High
Pressure
Hose
High
Pressure
Output Port
Control Manifold
Filter
Assembly Check Valve
Free
Flow