MK Diamond MK-MANTA III - Manual (Page 9)

9
UNPACKING
ASSEMBLY
Feed Handle and Meter Box
Vacuum Gasket
Open the accessory pack and check each item with the contents list, making certain that all items are
accounted for and in good condition before discarding any packing material. If there are any missing
or damaged parts, call our toll free number 1-800-421-5830 for instructions before proceeding with
the assembly.
Contents of the carton: It varies depending on model. MK-Manta III Core Drill (including column, car-
riage, base and motor), Vacuum Pump and Accessory Pack.
Contents of the Accessory Pack: Control box, meter box knob, leveling screw (4), feed handle (1) and
knobs (2), water valve, vacuum base gasket, wrench, MK-Manta III manual, MK Diamond warranty
card, motor manual and motor warranty card.
Name
address
City
state zip Code
phoNe Fax
e-mail
produCt model
part NumBer
maChiNe serial#
MK DiaMonD Warranty CarD
q tile distriButor q home CeNter q equipmeNt supply house q tool supply q Bldg material supply q reNtal equipmeNt house
are you a do-it-yourselFer q or CoNtraCtor q I F so, what type? tile q masoNry q other
what Criteria was importaNt iN ChoosiNg this saw? (rate From 1 to 5, 5 BeiNg the most importaNt) power preCisioN portaBility availaBility other
If within one (1) Year from the date of purchase, this MK Diamond saw fails due to defect in material or workmanship, MK will repair it, free of charge when the unit is re- turned to the dealer where it was purchased. This warranty DOES NOT cover normal wear or damage resulting from operator abuse. In no event shall MK Diamond Products, Inc. be liable for consequential damages arising out of the failure of any product if operated improperly. MK Diamond Products may act as a warranty station for motor/en- gine repairs based on an individual agreement with the manufacturer. This warranty is in lieu of all other warranties express or implied. ©2010 All Rights reserved. MK Diamond Products, Inc. • P/N 155037 MK Warranty Card (02/10)
mK diamoNd warraNty 1315 Storm Parkway, Torrance, CA 90509 USA | www.mkdiamond.com | 1.800.421.5830 | 1.310.539.5158
where did you purChase this saw From? Name
CommeNts or suggestioNs: priCe
date purChased
08.2012
MK-MANTA III OWNER’S MANUAL PARTS LIST & OPERATING INSTRUCTIONS
www.mkdiamond.com
Caution: Read all safety and operating instructions before using this equipment. This parts list MUST accompany the equipment at all times.
Revision 202
Manual Part# 161117
MK-Manta III Vacuum Pump
(Combination
Models Only)
Accessory Pack Control Box
Warranty
Card
Owners
Manual
MANTA CORE DRILL III CONTENTS
For your own safety and protection, do not attempt to operate this drill until it is
completely assembled and installed according to these instructions, and until
you understand the machines capabilities and the potential hazards associated
with it.
Turn the vacuum base over. Press the gasket into the groove in the underside of the base. The gas-
ket is cut at the factory to the correct length so that the two ends will butt together once the gasket is
installed.
Step 1: Slide carriage assembly onto column. Assemble handle and hub.
Step 2: Assemble the two pieces of the water valve, and install the valve into the water swivel on the
motor, just above the spindle (see Milwaukee literature).
WARNING