MK Diamond MK-MANTA III - Manual (Page 16)

16
Periodic maintenance, including cleaning, lubrication and inspection for wear and damage are routine
servicing procedures. Following the procedures as outlined can prevent serious damage or malfunc-
tioning of the machine, and aid in preserving the useful life of core drill bits.
Clean the machine after use, being careful to remove dust and slurry from the motor, vents, carriage
and column. Keep tool handles clean, dry and free of oil and grease. Use only mild soap and a damp
cloth to clean this tool since certain agents and solvents are harmful to plastics and other insulated
parts.
Through normal use, the rubber gasket on the underside of the vacuum base can become worn,
requiring replacement. Periodically check the gasket for wear. If replacement is required, clean the
groove in the base before installing a new gasket.
MAINTENANCE
CLEANING
VACUUM BASE GASKET
Before performing any maintenance to the MK-Manta III Core Drill,
always unplug the unit from the electrical power source. Ensure the
On-Off switch is in the Off position, after servicing, and before plugging
the unit back in.
Never use flammable or combustible solvents around tools.
CAUTION
WARNING
on
MANTA CORE DRILL III MAINTENANCE