MK Diamond MK-DDG - Manual (Page 10)

MK-DDG-11
B
C
A
H
J
E
C
I
D
J
10
WARNING
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition, California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
!
DO NOT operate
this equipment
before reading
the owners’
manual!
WARNING !
CAUTION
DO NOT
operate without
guards in place.
!
(A)
(B)
(C)
(D)
DANGER
The exhaust from this product
contains chemicals known to
the State of California to cause
cancer, birth defects or other
reproductive harm.
!
(E)
CAUTION
DO NOT
touch hot
surface.
!
DANGER
Lethal exhaust
gases. Use only
in well ventilated
areas. DO NOT
use indoors.
(F)
(G)
(H)
(L)
Electric Grinder
CAUTION
Accidental start hazard.
Disconnect spark plug
prior to servicing.
!
(I)
(J)
(K)
WARNING
When refueling
stop engine and
allow to cool.
DO NOT overfill
tank.
!
CAUTION
Keep
hands and
feet clear.
!
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
NOTICE
Overtensioning of belts
will result in premature
crank and/or bearing failure.
!
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
25’
50’
75’
100’
150’
250’
Max. Cord Lgth.
Max. Cord Lgth.
Max. Cord Lgth.
Max. Cord Lgth.
No. 12 Wire
No. 10 Wire
No. 8 Wire
No. 6 Wire
115v 230v
5 H.P.
230v
50’
100’
150’
250’
NOTICE !
Label Sheet Part# 166010
Electric Engine
SAFETY LABEL LOCATIONS
Safety and warning labels are located according to the figure below. The labels contain important
safety information. Please read the information contained on each safety label. These labels are
considered a permanent part of your saw. If a label comes off or becomes hard to read, contact
MK Diamond or your dealer for a replacement.
Wear eye protection.
Replace any damaged grinding discs before operating.
WARNING
MK-DDG SERIES SAFETY