MK Diamond MK-S - Manual (Page 7)

7
Do noT oVErrEacH
Keep proper footing and balance at all times by not overreaching.
MainTain TooLS wiTH carE
Keep tools sharp and clean for the best and safest performance. Always follow maintenance instruc-
tions for lubricating and when changing accessories.
SHUT Down TooL
The saw should always be shutdown before servicing or when changing accessories such as blades,
bits, cutters, etc...
USE rEcoMMEnDED accESSoriES
Consult the owner’s manual for recommended accessories. Using improper accessories may in-
crease the risk of personal or by-stander injury.
nEVEr STanD on THE TooL
Serious injury could occur if a power tool is tipped, or if a cutting tool is unintentionally contacted.
MK-S SaFETY
nEVEr LEaVE TooL rUnning UnaTTEnDED – TUrn PowEr oFF
Do not leave a tool until it comes to a complete stop. Always turn a power tool OFF when leaving the
work area, or, when a cut is finished.
cHEcK For DaMagED ParTS
Before using a power tool, check for damaged parts. A guard or any other part that is damaged
should be carefully checked to determine it would operate properly and perform its intended func-
tion. Always check moving parts for proper alignment or binding. Check for broken parts, mountings
and all other conditions that may affect the operation of the power tool. A guard or any damaged part
should be properly repaired or replaced.
DirEcTion oF FEED
Always feed work into a blade or cutter against the direction of rotation. A blade or cutter should al-
ways be installed such that rotation is in the direction of the arrow imprinted on the side of the blade
or cutter.