MK Diamond MK-S User Manual
Page 13
13
Before the first use, check all fasteners for tightness and review all Safety and Operating Instructions.
Before beginning the cutting work, check daily for regular tightness of all fasteners, especially those
attaching the blade to the saw.
Before switching the saw on, make sure that all protective housings are fitted and the dust collector
unit is correctly connected.
Handle all plugs, cables, hoses and operating elements carefully. Avoid contact with live wires.
Before cutting, clean the surface with a broom. There should not be any trash, stones, cloths or
standing liquid on the surface.
MK-S SETUP
Put the decorative saw and the required accessories onto the surface to be processed.
Assemble the center pivot base, as required for the application.
Fit the appropriate blade that is required for this particular process.
Using the correct cables, connect the machine and the dust collector to the electricity supply point.
These electric supply points should be protected and equipped with a GFCl Switch. (Residual current
operated device). In case of doubt, ask the local safety officer.