MK Diamond MK-212 - Manual (Page 20)

20
MK-212 SAW SETUP
MK-212 ELECTRICAL CORD SETUP
CAUTION
1. Before connecting the MK-212 to a power supply, be sure the voltage, cycle
and phase meet the requirements of the table below.
2. If using an extension cord, make sure the length and wire gauge correspond to the requirements
listed in the table on page 13. An extension cord that is too small in wire gauge (diameter), or too
long in length, will cause the motor to overheat and could cause premature failure.
3. Use an approved Ground Fault Circuit Interrupter (GFCI)
4. Do not cover the motor vents as this could lead to motor overheating.
VOLTAGE: 120v
CYCLE: 60hz
PHASE: 1-phase Single
Phase
NOTE: In order to avoid breaker tripping, a 20 amp circuit breaker should be used.
(B)
Plug the GFCI into the Power
source.
(A)
Plug MK-212 into the GFCI (A
GFCI should always be used
when operating the MK-212).
BLADE HEIGHT ADJUSTMENT
(A)
Use Cutting Head Height Lock
to adjust blade height.
(B)
The blade should not routinely
be set in the full down position
when cutting, only the diamond
segment of the blade is below
the table surface.