MK Diamond MK-212 - Manual (Page 16)

16
MK-212 SAW ASSEMBLY
DIAMOND BLADE INSTALLATION
NOTE: When installing the Retaining Nut, do not “cross-thread" and DO NOT over tighten the nut.
(A)
Loosen the Cutting Head
Locking Knob.
(C)
Place left hand on Cutting
Head handle.
(B)
Move the Cutting Head to one end
of the saw. Tighten the Cutting
Head Locking Knob.
(H)
Open the Blade Guard.
(G)
Loosen the Blade Guard Retaining
Knob.
(I)
Turning clockwise, loosen the Blade
Retaining Nut and remove from Blade
Shaft. Use the 5mm Allen Wrench if
necessary.
(D)
Loosen the Cutting Head
Height Lock.
(F)
Loosen the Blade Guard Pivot
Point Retaining Wingnut.
(E)
Raise Cutting Head. Retighten
Cutting Head Height Lock.