MK Diamond TX-3 - Manual (Page 14)

14
TX-3 INSPECTION & STARTUP
UNPACKING
If not already done, remove the TX-3 from the carton and place it on a flat surface. Check contents with list below:
CONTENTS
Your TX-3 has been shipped from the factory thoroughly inspected. Only minimal assembly is required.
1 2 3 4 5
6 7 8 9 10
11 12 13
ITEM NO. DESCRIPTION QUANTITY
1 TX-3 1
2 10” WET CUTTING TILE BLADE 1
3 ADJUSTABLE CUTTING GUIDE 1
4 SIDE CUTTING TABLE 1
5 DRAIN PLUG 1
6 WRENCHES 2
7 GROMMET 1
8 FILTER 1
9 WATER TANK 1
10 PLASTIC TUBING 1
11 NOZZLE, 1.0mm 2
12 ADAPTER 1
13 OPERATION & PARTS MANUAL 1
14 WARRANTY CARD 1
Caution: Read all safety and operating
instructions before
using this equipment. This manual MUST accompany
the equipment at all times.
TX-3
TILE SAW
OPERATION & PARTS MANUAL
www.mkdiamond.com
MK Diamond Products, Inc.
14