MK Diamond TX-3 - Manual (Page 12)

12
Safety labels are located on the back of the motor assembly (figure 3). The labels contain important safety in-
formation. Please read the information contained on each safety label. These labels are considered a permanent
part of your saw. Should any of these decals become unreadable, replacements can be obtained by calling
(800) 262-1575.
Fig. 4 TX-3 Safety Decal Sheet, Part #166787
OPERATION & SAFETY DECALS
TX-3 SAFETY
• For Your Own Safety Read Instruction Manual
Before Operating Saw.
• Wear Eye Protection.
• Disconnect Saw Before Servicing, when Changing
Cutting Wheels and Cleaning.
• Use Tool Only with Smooth Edge Cutting Wheels
Free of Openings and Grooves.
• Replace Damaged Cutting Wheel Before Operating.
• Do Not Fill Water Bath Above Water Fill Line.
• See Manual for Pump Replacement.
WARNING
Grinding/cutting/drilling of masonry, concrete,
metal and other materials with silica in their
composition may give off dust or mists contain-
ing crystalline silica. Silica is a basic component
of sand, quartz, brick clay, granite and numerous
other minerals and rocks. Repeated and/or sub-
stantial inhalation of airborne crystalline silica can
cause serious or fatal respiratory diseases, in-
cluding silicosis. In addition, California and some
other authorities have listed respirable crystalline
silica as a substance known to cause cancer.
!
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
25’
50’
75’ 100’
150’
250’
Max. Cord Length
Max. Cord Length
Max. Cord Length No. 12 Wire
No. 10 Wire
No. 8 Wire
115v 230v
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
!
NOTICE
Do not run misting
pump dry to avoid
failure of pump
NOTICE !
DO NOT operate
this equipment
before reading the
owners’ manual!
WARNING !
• Receptacle is for water
pump only.
• This saw is to be used
with a Ground Fault
Circuit Interrupter.
! CAUTION
Misting Version Only, Part #164800
Flood Version Only, Part #166634
Fig. 3 TX-3 Safety Decal Location