MK Diamond MK-145 220 Volt - Manual (Page 22)

MK Diamond Products Inc. Customer Service Department (800) 421-5830
MK-145 Revision 09/04, Effective date – September 23, 2004 Page 22
SETUP, ADJUSTMENT and OPERATION:
Cleanup:
STEP ACTION
Never empty the Cooling Basin with the ON/OFF switch in the
ON position, or when power is applied.
NOTE: DO NOT use solvents or acids when cleaning the MK-145.
1. De-energize the MK-145
a) Verify the ON/OFF switch is in the OFF
position
2. Un Plug the MK-145
a) Unplug the MK-145 from the power source
b) Unplug the MK-145 from the GCFI
3. Remove Water Basin Cover
a) Lift Water Basin Cover
b) Pull out on Water Basing Cover to remove
4. Empty Water Basin
a) Empty the contents of the Water Basin
(Conform to Federal, State and Local laws,
codes and ordinances relative to environmental
protection if unsure of disposal requirements)
During the cleaning process, do not allow water to enter the
motor compartment of the MK-145.
5. Cleaning
a) Clean the MK-145 with clean, fresh water and
dish soap
b) Rinse with clean water and dry the MK-145 with
a clean cloth or paper towels
Off Position
GFCI
Removal
Direction
Empty Water Basin
Soap and
Fresh Water