MK Diamond MK-145 220 Volt - Manual (Page 17)

MK Diamond Products Inc. Customer Service Department (800) 421-5830
MK-145 Revision 09/04, Effective date – September 23, 2004 Page 17
SETUP, ADJUSTMENT and OPERATION:
STEP ACTION
Overfilling the Water Basin can lead to water entering the motor
compartment and potential electric shock.
4. Filling the Water Basin
a) Fill the Water Basin UP TO the mark indicated
on the Water Level Label
5. Verify Water Level
a) Verify the Water Basin water level, is below the
Upper Limit Indicator Arrow
6. Reinstall the Water Basin Cover
a) Insert the three (3) Cover Retaining Tabs into
the three (3) Cover Alignment Slots
b) Seat the Water Basin Cover on the MK-145
If an extension cord is used, first verify it meets the requirements of TABLE
1 (page 9). Plug the MK-145 into the extension cord, plug the extension
cord into a GFCI and finally, plug the GFCI into the power source in that
order.
7. Verify the ON/OFF Switch is OFF
a) Verify the ON/OFF Switch is in the OFF position
8. Plug-in the MK-145
a) Plug the MK-145 into a GFCI
b) Plug the GFCI into the power source
Water Level
Indication
Alignment Slot
Retaining Tab
Off Position
GFCI
GFCI Plugged
Into Power
Source
Upper Limit
Indicator Arrow