Mk-370 saw maintenance – MK Diamond MK-370 User Manual

Page 20

(D)

Fill the Water Pan with

clean water

(B)

Dispose of the contents of

the Water Pan and clean

the pan. Replace the

Cutting Assembly.

(A)

Ensure the ON/OFF Switch is

in the OFF position. Remove

the Cutting Assembly from the

Water Pan

CLEANUP

Dispose of wastewater in accordance with applicable Federal, State and Local laws.

(C)

Clean the Water Pump of all

debris. (Refer to water pump

manual for more detail)

(E)

Run the MK-370 until clear

water is seen at the blade

cooling ports (Approx. 1

minute)

Ensure the saw is disconnected before completing the remainder of the

cleanup process.

CAUTION

NOTE:

MK-370 SAW MAINTENANCE

(F)

Dispose of the contents of the

Water Pan and clean the MK-

370 with soap and clear water

(G)

Clean the Guide Bar

(H)

Clean the Roller Wheel

Guide Rail

(I)

Clean the Roller Wheels

CAUTION

To extend the life of the MK370, lubricate the Motor Shaft with light oils such

as, 3 in 1, WD-40, etc.