MK Diamond MK-370 - Manual (Page 15)

15
MK-370 SAW INSTALLATION
When installing the Retaining Screw, do not "cross-thread" and DO NOT over tighten the screw.
(E)
Install Diamond Blade onto
Blade Shaft
(D)
Place the Blade Wrench on
the Blade Retaining Nut and
remove the Blade Retaining
Nut and Outer Flange
(F)
Verify the Directional Arrow of
the Blade faces outward and
matches the Directional Arrow
of the Blade Guard
(H)
Close the Blade Guard and
tighten the Blade Guard
Retaining Knob
(G)
Install the Outer Flange and
Retaining Nut; install the Shaft
Wrench and Blade Wrench as
shown in Steps C and D and
tighten the Retaining Nut
(I)
Tighten the Blade Guard
Retaining Wingnut