Metal Sales 5V-Crimp - Manual (Page 6)

P5V-6
5V-CRIMP
© Metal Sales Manufacturing Corporation/ Subject to change without notice/ Effective Date 9/11
800.406.7387 (Corporate Office) • www.metalsales.us.com
s
eCTion
P
roPerTies and
g
eneral
i
nforMaTion
ALLOWABLE UNIFORM LOADS PSF
(3 or More Equal Spans)
0'-6"
SECTION PROPERTIES
Bottom in Compression
Width
(in.)
Yield
KSI
24" 50 26
Ga.
Sxx
In 3 /ft
Ixx
In 4 /ft
Weight
PSF
0.77
Top in Compression
Sxx
In 3 /ft
Ixx
In 4 /ft
0.0025 0.0069 0.0015 0.0054
Outward Uplift Load
1'-0" 1'-6" 2'-0" 2'-6" 3'-0"
101 89 60 34 22 15
24" 50 24 1.02 0.0030 0.0089 0.0020 0.0073 101 89 60 34 22 15
1. Theoretical section properties have been calculated per AISI 2001. “Specifications for the Design of Cold-formed Steel Structural
Members.” Ixx and Sxx are effective section properties for deflection and bending.
2. Allowable load is calculated in accordance with AISI 2001 specifications considering bending, shear, combined bending and shear and
deflection. Allowable load considers both 3 or more equal span conditions. Allowable load does not address web crippling or
fasteners/support connection. Panel weight is not considered.
3. Deflection consideration is limited by a maximum deflection ratio of L/180 of span.
4. Allowable loads do not include a 1/3 stress increase in uplift.
12"
1 /
2
"
C
24" Coverage
#9-15x2" Woodscrew  Slope
 Substructure
 Coverage
 Length
 Fasteners
 Availability
GENERAL INFORMATION ATTACHMENT DETAIL
FASTENING PATTERNS
The minimum recommended slope for 5V-Crimp roofing
panel is 3:12.
*Contact Metal Sales Technical Services for Miami-Dade County attachment requirements.
#9-15x2" Woodscrew
#9-15x2" Woodscrew
Field of Panel
Ends of Panel
The recommended substrate is 5 /
8
" plywood with a 30
pound felt moisture barrier. To avoid panel distortion use
a properly aligned and uniform substructure.
NOTE: 5V-Crimp roof panels are not recommended for
use over open structural framing.
Minimum factory cut length is 5'-0". Maximum
recommended panel length is 45'-0". Longer panels
require additional consideration in packaging, shipping, and
erection. Please consult Metal Sales for recommendations.
The fastener selection guide should be consulted for
choosing the proper fastener for specific applications.
Quantity and type of fastener must meet necessary loading
and code requirements.
NOTE: All panels are subject to surface distortion due to
improperly applied fasteners. Overdriven fasteners will
cause stress and induce oil canning across the face of the
panel at or near the point of attachment.
Finishes: Acrylic Coated Galvalume ® and MS Color-
fast45 ®
Gauges: 26ga and 24ga
5V-Crimp panels are available in a 1 /
2
" rib height with a
coverage width of 24".