MBT Lighting CA1612 - Manual (Page 6)

8.)Then press a Button 1~8 to store the scene.All LEDs blink 3 times. Scene
The LCD will display the bank and scene where your scene was stored.
9.)Repeat steps 2~8 to recordy our desired scenes.
You can copy the settings from one scanner button to another in case you
want to add more fixtures to your show.Just press and hold the scanner
button you want to copy,then press the scanner button you want to copy to.
10.)To exit programming mode press and hold the button for 3 Program
seconds.
(When you exit programming,the Blackout LED is on, press Blackout
button to de-function blackout.)
Scene Editing
This function allows you to make changes in aprevious program med scene .
1.)Press th e button for three seconds to enter program mode. Program
2.)Use th e Up and Down button to select the bank that stores the Bank
scene you wish to edit.
3.)Select the scene you want to edit by pressing its button. Scene
4.)Use the faders to make your desired adjustments.
5.)Press the
button then followed by the button that MIDI/Add Scene
corresponds to the scene you editing to store it tomemory.Note:You
must select the same scene you selected earlier otherwise you may
accidentally record over an existing scene.
Scene Copy
This allows you to copy the setting so fone scene to another.
1.)Press th e
button for three seconds to enter program mode. Program
2.)Use the Bank Up and Down to locate the bank that stores the Button
Scene to copy.
3.)Select desired Scene you want to copy by pressing the button. Scene
4.)Use the buttons Up and Down to select the bank where you want Bank
To store the copied scene.
5.)Pres s followed by the Button where you want to copy to. MIDI/Add Scene
Delet e Scene
This function will reset all DMX channels in corporated with a scene to 0.
1.)Select the desired scene to delete.
2.)While pressing and holding Auto/Del,press the Scene button(1to8)
you want to delete.