Mayline TMATE Tables - Manual (Page 2)

Adder Assembly
5. Attach Leg (2) onto Starter/Adder Top using three Screws (E1) & three Washers (E5) for each top. See Fig #5
Assembly:
1. Assemble Glides (E2) into inner most threaded holes in Leg (2).
Install End Caps (E3) into Leg (2).
Stand Alone & Starter Assembly
2. Begin Assembly by determining if the table will be a stand alone unit or if there will be other tables attached. If
stand alone unit is chosen see Fig. #2 & #3. If Starter/Adder Assembly is chosen see Fig. #2 & #4.
3. Place Top (1) face down on a clean flat surface. Attach Leg Assembly (2) onto Top using six Screws (E1) &
six Washers (E5) per Leg.
4. Attach Stiffener (3) using Screws (E4) as shown in Fig. #3 & #4. NOTE: Stiffeners are included on tables
larger than 48".
Fig. #5
(2)