Mayline CSII Privacy Panels - Manual (Page 6)

(6)
Stepped Height Finishing Kit
Procedure is similar to that of the 180° Finishing Kit on page 2.
1. REFER TO BASIC PANEL ASSEMBLY INSTRUCTIONS ON
PAGE 1.
2. Place one Stacked Panel with Base Posts along the edge of the
Top at the desired location. Attach this assembled Panel to the
Work Surface edge using two Screws (E2) per Base Post by
driving screws through edge banding. Attach each Base Post to
the Work Surface with one Screw (E2) per Post. Use 'CAUTION'
when installing screw into the Work Surface laminate to prevent
marring the finish.
3. At the location of the 'Step', install the stacking post and filler
strip to the lower of the two panels. Install the outer flush strip to
each side of the assembly. Attach second panel to the Work
Surface edge using two Screws (E2) per Base Post by driving
screws through edge banding. Attach each Base Post to the Work
Surface face with one Screw (E2) per Post. Use 'CAUTION' when
installing screw into the Work Surface laminate to prevent marring
the finish.
4. Using the appropriate Finishing Kit Components, extend the
Panels to the desired length. Attach these additional Panels to the
Work Surface edge as described above. Insert Caps to complete
each connection.
NOTE:
When ordering components, specific color and/or size information is required.
Contact a Mayline Customer Service Representative. 1-800-822-8037
CATALOG No:
C9511
C9512
C9513
'OUTER'
Flush Strip
Stacking Post
'OUTER'
Flush Strip
Finishing Strip
Cap