Mayline CSII Privacy Panels - Manual (Page 3)

(3)
Two Way - 90° - Connection :
1. REFER TO BASIC PANEL ASSEMBLY INSTRUCTIONS ON PAGE 1.
2. Place one assembled Panel with Base Posts - Single or Stacked - along the edge of the Top at the desired
location. Place the second assembled Panel at 90° to the first panel and insert the inner and outer corner filler strip
from the 90° Two Way Finishing Kit to maintain conf iguration. Attach these assembled Panels to the Work Surface
edge using two Screws (E2) per Base Post by driving screws through edge banding. Attach each Base Post to the
Work Surface face with one Screw (E2) per Post. Use 'CAUTION' when installing screw into the Work Surface
laminate to prevent marring the finish.
3. Using the appropriate Finishing Kit Components, extend the Panels to the desired length in each direction.
Attach these additional Panels to the Work Surface as described above. Insert Caps to complete each connection.
NOTE:
When ordering components, specific color and/or size
information is required. Contact a Mayline Customer
Service Representative. 1-800-822-8037
CATALOG No:
C9211
C9212
C9213
'INNER'
Corner Strip
'OUTER'
Corner Strip