Mayline CSII Privacy Panels - Manual (Page 2)

(2)
FOR PRIVACY PANEL CONFIGURATIONS WITH MORE THAN ONE
PANEL, SEE INSTRUCTIONS FOR THE CORRESPONDING
FINISHING KITS ON THE FOLLOWING PAGES.
Two Way - 180° - Connection :
1. REFER TO BASIC PANEL ASSEMBLY INSTRUCTIONS ON PAGE 1.
2. Place one assembled Panel with Base Posts - Single or Stacked - along the edge of the Top at the desired
location. Attach this assembled Panel to the Work Surface edge using two Screws (E2) per Base Post by driving
screws through edge banding. Attach each Base Post to the Work Surface face with one Screw (E2) per Post.
Use 'CAUTION' when installing screw into the Work Surface laminate to prevent marring the finish.
3. Using the appropriate Finishing Kit Components, extend the Panels to the desired length. Attach these
additional Panels to the Work Surface as described above. Insert Caps to complete each connection.
'OUTER'
Flush Strip
'OUTER'
Flush Strip
Cap
CATALOG No:
C9111
C9112
C9113
NOTE:
When ordering components, specific color and/or size
information is required. Contact a Mayline Customer
Service Representative. 1-800-822-8037