Mayline CSII Privacy Panels - Manual

(1)
Prior to assembling the Privacy Panel System, identify Panel top and bottom edge.
A.) 'FABRIC' Panel system. The panel 'TOP' is the smooth, fabric edge.
B.) 'LAMINATE' Panel system. Either edge may be used as the 'TOP'.
1. Place a Panel (1) on its side and fully insert the Right and Left Base Post (2 &
3) into the bottom of the Panel side moldings. Position the Base Post with the
tapered edge toward the outside of each panel. Base posts are only required in
the panels that will be directly attached to the work surface.
2. A stackable panel system requires the use of the Stacking Post (4). Align the
shape of the stacking post stop with the shape of the panel side molding. Fully
insert the stacking post into the panel molding. Align the upper panel moldings
with the stacking posts and lower the panel.
3. Place one assembled Panel with Base Posts - Single or Stacked - along the
edge of the Top at the desired location. Attach this assembled Panel to the Work
Surface edge using two Screws (E2) per Base Post by driving screws through
edge banding. Attach each Base Post to the Work Surface face with one Screw
(E2) per Post. Use 'CAUTION' when installing screw into the Work Surface
laminate to prevent marring the finish.
4. Insert End Caps (E1) to complete the panel assembly.
OPTIONAL:
5. If your furniture arrangement places the Privacy Panel against a Hutch. Apply
the Double Sided Tape (E3) to the panel end extrusion that abuts the hutch.
Remove the protective backing and adhere the Privacy Panel to the Hutch end.
Bracket taper
to 'OUTSIDE'
2 3
1
4
E1
When ordering components, specific color and/or size
information is required. Contact a Mayline Customer
Service Representative. 1-800-822-8037
COMPONENTS:
REF. # QTY. DESCRIPTION PART No.
1 1 PANEL CALL~~**
2 1 R.H. BASE POST A7580**
3 1 L.H. BASE POST A7661**
4 2 STACKING POST A7581**
ASSEMBLY INSTRUCTIONS
CS II PRIVACY PANELS
BASIC PANEL ASSEMBLY:
DUE TO THE FLEXIBILITY OF THE PRIVACY PANELS, IT IS RECOMMENDED THAT ALL
PANELS AND FINISHING KITS BE FULLY ASSEMBLED TO ENSURE PROPER ALIGNMENT
PRIOR TO FASTENING TO THE WORK SURFACE
NOTE: Please count and inspect all pieces before disposing of any
carton or packing materials.
HARDWARE BAG ( PART No. A7671**)
REF. # QTY DESCRIPTION PART No.
E1 2 END CAP F727**
E2 6 #6 X 1" SCREW X14**
E3 1 DOUBLE SIDED TAPE E515 ** Denotes Color Code ~~ Denotes Size