Longevity WeldAll 160PI/200PI/250PI - Manual (Page 35)

160/200/250PI AC/DC Series IGBT Machine
www.LWELD.com
Basic Installation for TIG Function:
1. Plug the argon regulator to the bottle.
2. Plug the torch into the unit on the right side of the unit (+)
3. Either plug the pedal or the remote 7 pin connector to the machine. You cannot plug both in.
4. Plug the ground clamp into the left side din Ground Clamp Din (+) is plugged on the right side
(+) and attaches on the work piece.
5. Plug in the Power Cord to the wall.
Refer to past image: