Lenze EPM−H310 - Manual (Page 41)

Preface and general information
About these Operating Instructions
1
l
41 EDBPM−H310 DE/EN/FR 7.1
1 Preface and general information
The EPM−H310 operating unit enables you to access codes of Lenze controllers,
9300 Servo PLCs and Drive PLCs and to control them easily. Communication
takes place via the system bus (CAN).
The »HMI Designer« is a powerful development environment for creating
projects containing the configuration of the operating unit.
1.1 About these Operating Instructions
ƒ These Operating Instructions describe safe and trouble−free working on
and with the EPM−H310 operating unit.
ƒ All persons working on and with the EPM−H310 operating unit must have
these Operating Instructions available and observe all relevant
information and notes.
ƒ These Operating Instructions must always be kept as a complete
document and in a readable state.
1.2 Terminology used
Term Used in this text for
Controller Lenze 8200 vector and 9300 vector frequency inverter, Lenze 9300
and 9400 servo inverter
HMI Human Machine Interface
1.3 Scope of supply
Scope of supply Important
l 1 EPM−H310 operating unit
l 1 Operating Instructions
l 2 mounting clamps
l 2 screws
l 1 seal
l 1 terminal strip, 4−pole for connection of DC
voltage supply
l 1 terminal strip, 5−pole for system bus (CAN)
connection
After receipt of the delivery, immediately check
whether the items delivered match the
accompanying papers. Lenze does not accept
any liability for deficiencies claimed
subsequently.
Claim
l visible transport damage immediately to the
forwarder.
l visible deficiencies/incompleteness
immediately to your Lenze representative.