Lenze E82ZAFLC010 - Manual (Page 44)

5 Commissioning
Initial switch−on
EDK82ZAFLC−010 DE/EN/FR 4.0
44
l
H1inbet−statusanzeige
Initial switch−on
)
Note!
ƒ The standard device is only ready for operation if a HIGH level is applied to
terminal 28 (controller enable via terminal).
– Please note that the controller can be inhibited by various sources. The
sources act like a series connection of switches.
– If the drive does not start even though the controller has been enabled
via terminal 28, check whether the controller has been inhibited by
another source. Another source could be the
s key on the keypad.
ƒ Please note the different status information for code C0068 compared to
software version "0.1" (see the following table).
Bit Function Description
8 RFR (controller enable) 0: no controller enable
1: controller enable
11 IMP (pulse inhibit) 0: pulses for power sections inhibited
1: pulses for power sections enabled
15 TRIP (fault) 0: no fault
1: fault exists