Lenze GKK - Manual (Page 20)

Maintenance
Maintenance intervals
7
20 BA 12.0032-EN 2.0
7 Maintenance
Gearboxes and geared motors from Lenze are filled with a drive-specific and
design-specific lubricant filling at delivery. The mounting position and design are decisive
at ordering for the required lubricant quantity.
Note!
When changing the lubricant, Lenze recommends also changing the grease
packing of the bearings and replacing the radial shaft seal rings!
7.1 Maintenance intervals
ƒ The mechanical power transmission system is free of maintenance.
ƒ
Lubricating intervals:
– A lubricant change must be performed at regular intervals for gearboxes of type
GKK.
– The type of lubricant is indicated on the nameplate. Replace the lubricant only by
the same type.
– Maintenance intervals: see ”Tab. 2”.
ƒ Shaft seals:
– The service life depends on the operating conditions.
– Replace seals in case of leakage to avoid consequential damage.
Lubricants Changing intervals
Type Specification Ambient
temperature
Note
g g
CLP 460 Oil on mineral basis
with additives
0 °C ... + 40 °C 16,000 hours of operation -
after three years at the latest
(oil temperature 70 ... 80 °C)
CLP PG 460 Oil on synthetic basis
(polyglycol)
-20 °C ... + 40 °C Do not mix with
mineral oils!
25,000 hours of operation -
after three years at the latest
(oil temperature 70 ... 80 °C)
CLP HC 220
(H1)
Food-compatible oil
on synthetic basis
-20 °C ... + 40 °C Approval acc. to
USDA-H1
16000 hours of operation -
after three years at the latest
(oil temperature 70 ... 80 °C)
Tab. 2 Overview of lubricant change