Leica Biosystems HI1210 - Manual (Page 10)

10 Instructions for Use V 3.2 RevE – 02/2013
4. Instrument Setup
4.1 Location conditions
• When installing the power cable, always be sure to route it so that it cannot contact the
heated surfaces of the instrument at any time.
• The power socket to which the instrument is to be connected to has to be located near the
instrument and easily accessible.
• The power supply must be at a distance no greater than the length of the power cable – an
extension cable must NOT be used.
• The substrate must be largely vibration-free and have sufficient load capacity and rigidity
for the weight of the instrument.
• Avoid impacts, bright direct light, and excessive temperature fluctuations.
• The instrument must be connected to a suitable power socket.Use only the provided power
cable, which is intended for the local power supply.
4.2 Unpacking and Setting Up the HI1210
Fig. 3
Fig. 2
Set the carton on a flat surface, cut through
the adhesive tape ( Fig. 2 ) and open the
carton ( Fig. 3 ).