Koolance RP-1200 - Manual (Page 13)

18 19 User Manual
With the connected outlet
hose, roughly estimate the
length you will need to your
first cooler, and cut it.
Cut the second hose with
enough length to reach the
last water block that will be in
your system.
Using the leftover tubing, cut
shorter pieces to link between
each individual cooler.
Installation
Chapter
3
Filling & Maintenance
Liquid Coolers
You should now install the liquid coolers (CPU, GPU, Hard
Drive, etc.) to your hardware before continuing this User Manual.
Please refer to your cooler kit’s individual installation instructions,
then continue on to the next section.
WARNING :
The cooling system’s pump can not be run dry for any
period of time. Never power-on the computer or cooling system without
sufficient liquid in the reservoir. Dry-running (and thereby damaging
the pump) is not covered under the Koolance product warranty. !
Continue connecting all of
your coolers in the system
until there are no longer
any open tube ends.
NOTE: When filling the reservoir later, it will need to be pulled out from the front
chassis drive bay by about 2.75” (7cm). Be sure to leave enough tubing between
the reservoir unit and connected components to do this.