Kisan Electronics TPM-60 - Manual (Page 4)

2
TPM-20
SCREW ON VALVE-CAP SENSOR:
For the TPM-20 sensors, the integrity of the existing tire valves is vitally important. Please inspect each
tire valve carefully.
ƒ Not recommended for long body – over 2” – or rubber tire valves.
ƒ Screw-on sensors are best suited
for short metal tire valves
ƒ
Valve-stem should not be bent
– MUST be straight up vertically
ƒ Remove the existing valve caps
and inspect the threads
ƒ Check to see that the valve core is
not extending past the neck
ƒ You can repair minor scratches or a slight damage
to the threads of the tire valve.
Use the 4-Way tool to chase the entire length of the
threads by twisting ½ turn then backing off each time
– use thread lubricant or tapping fluid.
If you find any damage to the tire valve, it is highly recommended to
either replace it or purchase the TPM-30 tireAlert
2.0 system.
Inspect tire valves
carefully before you begin
installing sensors.
Use the 4-Way tool
supplied to recondition
the threads of the valve-
stem. This will help with
proper installation.