Kisan Electronics TPM-60 - Manual (Page 15)

13
tireAlert
2.0 Display is programmed to operate in two distinct modes: Pressure Monitoring Mode and
Performance Capture Mode. Upon power-up the default mode is Pressure Monitoring in scaled-back
display – normal temperature related pressure increases are stored in memory. You can change to
Instantaneous mode to briefly see the actual tire pressures. They can rise up as much as 12 PSI !
You can also select metric or English units for display.
NORMAL START-UP DISPLAY ROUTINE
(PSI Mode Shown)
ƒ
As the Display is powered with ignition on, it performs
Initialization and a system integrity check.
z
All segments are turned on briefly.
ƒ
Tire pressures are recalled from previous setting.
z
Front & Rear tire icons and pressures are on briefly.
ƒ
Next, the system attempts to acquire tire pressures.
z
Horizontal bar graph flashes sequentially
ƒ
Tire pressures are captured and displayed.
z
Front & Rear tire icons and pressures shown.
TWO STAGE WARNING SEQUENCE
(PSI Mode Shown)
ƒ
1st Stage warning activated, if the pressure drops 4 PSI
z
Tire icon and pressure readings flash.
ƒ
2nd Stage warning activated, if pressure drops 6 PSI
z
Tire icon and pressure readings flash.
z
Backlight color changes to red.
DISPLAY UNITS
To change from English to
Metric units of
measurement:
n Push & Hold the Mode
button down. The BAR
icon will light up.
o Immediately LET GO.
INSTANTANEOUS MODE
In this mode, tireAlert will
show non-compensated
pressure display, instead
of the scaled-back cold
tire pressures.
n Push & Hold the Mode
button down. First the
BAR icon will light up,
then the backlight will turn
RED.
o Now you can LET GO.