Kargo Master Drop Down Ladder Rack (40853) - Manual (Page 13)

L
M
12
VAN REAR
VAN FRONT
DETAIL L
SCALE 1 : 4
Location "A"
Extension
Ladder
Location "B"
Step Ladder
5/16x3/4
Bolt
5/16Lock
Washer
5/16 Flat
Washer
5/16 Nylock
Nut
5/16 Flat
Washer
Step 10
40853 is designed to carry and secure either an extension or a step ladder. If the
end-user intends to carry an extension ladder, attach Hinge Assembly Item-006 to
the REAR BOW at location "A". If the end-user intends to carry a step ladder, attach
Hinge Assembly to the REAR BOW at location "B". The Hinge Assembly is always
attached to the FRONT BOW at location "A". If the type of ladder to be carried is
unknown, default to the extension ladder set up. The end-user can relocate the
Hinge Assembly in the field if necessary. There is a label on the rack and separate
instruction sheet attached to the rack in a plastic pouch. See Diagrams below.
Slide the front and rear Hinge Assemblies onto the Ladder Pans at the correct
location, either "A" or "B". Attach to the "A" location (where there is a threaded stud)
using 4 x 5/16" flat washers, and lock nuts. See Detail M below. Attach to the "B"
location (where there is a threaded press nut inside the Bow) using 4 x 5/16" x 3/4"
bolts, lock wahsers and flat washers. These fasteners are attached to the REAR Bow
at the factory. See Detail L below.
Hinge Assy.
Item-006