Kargo Master Pro III Steel Ladder Rack – With A Camper Shell (80030) - Manual (Page 4)

G
N
K
SILIC
ONE
STEP 1
STEP 2
#1 = Cover and seal swedge joints with silicone
sealant and join FRONT and REAR side channels
together, there is a LEFT & RIGHT FRONT, with
the Right marked with a GREEN dot on the
overlapping plate. There is a RIGHT & LEFT
REAR. The leg cups angle outward. Be sure the
connecting plates overlap, and bolt together with
bolts G, washers K and lock nuts N.
#1 = Slide the FRONT leg onto the front side
channel. There is a RIGHT & a LEFT.
Match to the correct side channel so that both
FRONT & REAR legs angle outward.
Insert the set screws P, but do not tighten yet.
#2 = Loosely attach the top CLAMP with
bolts F, washers K, and nuts N.
#3 = Final positioning of the front legs will
follow in STEP 8.
#1 = Cover and seal swedge joints with
silicone sealant and attach the REAR LEGS
with bolts C, washers J, and nuts M.
Note: The distance between front & rear
legs will not be longer than the inside
measurements of the bed itself.
F
P
N
K
STEP 3
SILIC
ON
E
C
J
M
Pro 3KS _1.1-’06
(RIGHT SIDE SHOWN)