New Buck Corporation 21 - Manual (Page 23)

OPTIONAL ROOM AIR BLOWER (#MA T3714) INSTALLATION:
The MA T3714 Optional Room Blower kit:
[1] Remove the three (3) phillips head screws on the rear of the heater, and remove the air
channel shield.
[2] There are two (2) wires attached to the blower motor with connectors on the ends. Push
the two (2) wires through the round 5/8" hole located in the bottom of the back panel of
the heater. Continue to push the wires up the outer back of the firebox on the right rear
side until they come to the top of the air channel opening.
[3] Next take the thermostat provided with the kit and connect the two wires from the blower
to the terminals on the thermostat.
[4] Push the thermostat into the thermostat bracket located on the right rear side of the heater
between the outer back of the firebox and the rear back panel.
[5] Align the motor channel with the opening located in the bottom of the back panel of the
heater. Push the motor channel end into the opening. Align the four (4) holes in the mount-
ing brackets with the four (4) holes in the back panel and secure the brackets to the back
panel with the four hex head screws provided with the blower kit.
THERMOSTAT
THERMOSTAT
BRACKET
HEX HEAD
SCREWS
POWER CORD
MOUNTING BRACKET
BACK PANEL
PHILLIPS HEAD SCREWS
OUTER BACK OF
THE FIREBOX
MOTOR CHANNEL
21