JULABO ME-26 Heating Circulators - Manual (Page 17)

ME
17
JULABO
Description Thermal
H10 Thermal
H20S Thermal
H200
Order Number 10 liters 8 940 114 8 940 108 8 940 134
5 liters 8 940 115 8 940 109 8 940 135
Temperature range °C -20 ... 180 0 ... 220 60 ...200
Flash point °C 190 230 292
Fire point °C 216 274 334
Color clear light brown clear
See website for list of recommended bath fluids.
ATTENTION: The maximum permissible viscosity is 50 mm 2 /s.
Caution:
Fire or other dangers when using bath fluids that are not recommended:
Use only nonacidic and noncorrosive bath fluids.
JULABO assumes no liability for damage caused by the selection of an unsuitable
bath liquid.
Unsuitable bath fluids are fluids which, e.g.,
 are highly viscous
(much higher than recommended at the respective working temperature)
 have a low viscosity and have creep characteristics
 have corrosive characteristics or
 tend to crack.
 No liability for use of other bath fluids!
5.3. Temperature application to external systems
Caution: Securely attach all tubing to prevent slipping.
If the circulator is operated without external system, close the pump connector (24a)
with the cap nut.
 
feed return
The circulator is used for temperature application to external,
closed systems (loop circuit) with simultaneous temperature
application in the circulator bath.
Connecting the external system
 Unscrew the collar nuts from the pump connector (24a).
 Slide the tubing onto the pump connector for feed (24a) and
return flow (24b) and secure with hose clamps.