JULABO FK31-SL Calibration Baths - Manual (Page 20)

Preparations
20
5.2. Bath fluids
Caution:
Carefully read the safety data sheet of the bath fluid used, particularly with regard to
the fire point!
If a bath fluid with a fire point of
65 °C is used, only supervised operation is possible.
Water: The quality of water depends on local conditions.
 Due to the high concentration of lime, hard water is not suitable for temperature
control because it leads to calcification in the bath.
 Ferrous water can cause corrosion - even on stainless steel.
 Chloric water can cause pitting corrosion.
 Distilled and deionized water is unsuitable. Their special properties cause
corrosion in the bath, even in stainless steel.
Recommended bath fluids:
Bath fluid Temperature range
soft/decalcified water 5 °C to 80 °C
mixture water/glycol, mixture 1:1
-20°C to 50°C
JULABO bath fluids
JULABO
Description Thermal
G Thermal
HY Thermal
H5
Order Number 10 liters 8 940 124 8 940 104 8 940 106
5 liters 8 940 125 8 940 105 8 940 107
Temperature range °C -30 ... 80 -80 ... 55 -50 ...105
Flash point °C -- 78 124
Fire point °C -- 80 142
Color light yellow clear clear
JULABO
Description Thermal
H10 Thermal
H20S
Order Number 10 liters 8 940 114 8 940 108
5 liters 8 940 115 8 940 109
Temperature range °C -20 ... 180 0 ... 220
Flash point °C 190 230
Fire point °C 216 274
Color clear light brown
See website for list of recommended bath fluids.
ATTENTION: The maximum permissible viscosity is 70 mm 2 /s.
Caution:
Fire or other dangers when using bath fluids that are not recommended:
Use only non-acidic and non-corroding bath fluids.
JULABO assumes no liability for damage caused by the selection of an unsuitable
bath liquid.
Unsuitable bath fluids are fluids which, e.g.,