Bryant 701A - Manual (Page 3)

Fig. 2—701A030-042 and 702A030, 036 Unit Dimensions
UNIT ELECTRICAL CHARACTERISTICS
UNIT WEIGHT
UNIT HEIGHT
IN. (MM)
”A”
CENTER OF GRAVITY
IN. (MM)
lb. kg X Y Z
701A030 208/230-3-60 258 117.0 35.02 (889.5) 19.0 (482.6) 14.0 (355.6) 15.0 (381.0)
701A036 208/230-3-60, 460-3-60 268 121.6 37.02 (940.3) 20.0 (508.0) 14.0 (355.6) 13.0 (330.2)
701A042 208/230-3-60, 460-3-60 294 133.3 35.02 (889.5) 19.0 (482.6) 14.0 (355.6) 13.0 (330.2)
702A030 208/230-3-60 291 132.0 39.02 (991.1) 19.5 (495.3) 15.5 (393.7) 17.6 (447.0)
702A036 208/230-3-60, 460-3-60 299 135.6 35.02 (889.5) 19.5 (495.3) 15.25 (387.4) 16.5 (419.1)
C99007
REQUIRED CLEARANCE FOR OPERATION AND SERVICING
INCHES [mm]
EVAP. COIL ACCESS SIDE............................................................36.00 [914.0]
POWER ENTRY SIDE....................................................................42.00 [1066.8]
(EXCEPT FOR NEC REQUIREMENTS)
UNIT TOP .......................................................................................48.00 [1219.2]
SIDE OPPOSITE DUCTS ..............................................................36.00 [914.0]
DUCT PANEL .................................................................................12.00 [304.8] *
*MINIMUM DISTANCES: IF UNIT IS PLACED LESS THAN 304.8 [12.00] FROM
WALL SYSTEM, THEN SYSTEM PERFORMANCE MAYBE COMPROMISE.
REQUIRED CLEARANCE TO COMBUSTIBLE MATL.
INCHES [mm]
TOP OF UNIT ...................................................................................14.00 [355.6]
DUCT SIDE OF UNIT.........................................................................2.00 [50.8]
SIDE OPPOSITE DUCTS ................................................................14.00 [355.6]
BOTTOM OF UNIT .............................................................................0.50 [12.7]
ELECTRIC HEAT PANEL .................................................................36.00 [914.4]
NEC. REQUIRED CLEARANCES.
INCHES [mm]
BETWEEN UNITS, POWER ENTRY SIDE ....................................42.00 [1066.8]
UNIT AND UNGROUNDED SURFACES, POWER ENTRY SIDE .36.00 [914.0]
UNIT AND BLOCK OR CONCRETE WALLS AND OTHER
GROUNDED SURFACES, POWER ENTRY SIDE.........................42.00 [1066.8]
—3—