HYDAC HMG 510 - Manual (Page 14)

14
All measurement channels which have been rezeroed are designated by a
blinking measurement unit for safety reasons (see screenshot).
Caution!
A high pressure may still be present in a measurement channel featuring
a blinking unit of measurement even though the pressure reading
shows 0 bar.
When removing a sensor or other system components make sure the
system has been depressurized first. Failure to do this may pose a
hazard to life and limb.
Setting the Unit of
Measurement
The HMG 510 automatically
recognizes the unit of
measurement of the connected
HSI sensors. If you want to
display the measured value using
another unit of measurement, you
can set this via the Mode key (see
Menu Structure and Navigation of
the HMG 510
starting on page
14). The HMG 510 automatically
converts the measured value into
the new unit of measurement.