Heidolph EKT Hei-Con G - Manual (Page 21)

21
E
2.3 Mounting the temperature controller
The EKT holder (A) can be mounted using clamps (B) for Ø 10 mm or 13 mm
(for holder 509-81000-00 use clamp Ø 13 mm). Store the other clamps in a safe
place for later use.
Push the clamps onto the back of the holder
Notch the clamps onto the supporting rod (C)
Insert the EKT Hei-Con in the holder from above
Clamp the temperature measuring sensor (P) in the holder (F)
2.4 Electrical connection
•
Pull out the short-circuit termination (J).
•
Insert the 5-pole plug (K) of the spiral EKT cable into socket (I) on the back of the
instrument.