Gardman Lean-to Greenhouse - Manual (Page 4)

Introduction
Safety
Precautions when assembling a Gardman greenhouse:
The wearing of protective gloves and stout footwear is essential when handling glass and recommended even for
Polycarbonate which does not shatter but has sharp edges.
Protective goggles are recommended whilst handling glass and the glazing spring clips.
Assembly of the greenhouse frame is much easier with two people and essential for glazing with glass.
Site selection:
Choose a site in maximum light, ideally with no direct shade.
Avoid overhanging trees as much as possible as leaves will make regular cleaning necessary and broken branches are a
potential hazard.
Small trees, bushes or fences nearby can be helpful, acting as a wind break.
A position close to the house will make access easier for watering and tending plants and also make it easier to
supply power cables or automatic watering systems if required.
Site selection & preparation:
The site must be prepared so that the base of the greenhouse is level all round and checking with a spirit level is
required.
Base options & construction:
The use of a Gardman, purpose-made, galvanised steel base is recommended.
They are made to fit Gardman greenhouses.
It is easier to maintain a level and square foundation.
They are easy to install, requiring little expertise: full instructions are included in the pack.
Bases can also be constructed from bricks, blocks, or mounted on a concrete pad.
The bricks or blocks should be cemented onto firm and level concrete footings and the greenhouse frame drilled and
screwed to the base. Fig3.
If a concrete pad is made, it is important that this slopes away from buildings and walls to prevent water damage.
Time must be allowed for any concrete or cement to dry before mounting the greenhouse.
The base must be square or the greenhouse will be distorted. A=A Fig1 & B=B Fig2.
The greenhouse must be firmly fixed to the ground and to the wall: the base should be constructed and installed
before the greenhouse assembly is undertaken.
A
A
A = A
When the diagonal
measurements are equal,
the base will be square.
Screw & Plug
Greenhouse
Frame
Batten
Brick base
Concrete pad
Fig1
Fig2
Fig3
B B
08835.rev6 11/4/06 3:26 pm Page 4